3D-Drucker im Tech-Lab

This is an old revision of the document!

Start G-Code:

G28 X0 Y0; Home X and Y
G28 Z0; Home Z
G21 ; mm
G90 ; abs
G92 E0 ; reset extr
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X10.1 Y20 Z0.3 F5000.0 ; Move to start position
G1 X10.1 Y200.0 Z0.3 F1500.0 E15 ; Draw the first line
G1 X10.4 Y200.0 Z0.3 F5000.0 ; Move to side a little
G1 X10.4 Y20 Z0.3 F1500.0 E30 ; Draw the second line
G92 E0 ; Reset Extruder
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X5 Y20 Z0.3 F5000.0 ; Move over to prevent blob squish

End G-Code

G101 Z40; Lower the bed with 40mm
G28 X Y; Home X and Y
G92 E1 ; retract filament
M104 S0 ; turn off extruder
M140 S0 ; turn off bed
M84 ; disable motors